|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
How to store a program on the Drive Station?
I figured out how to program the robot but everytime I shut off the robot or the DS I have to reinstall it back on to the DS. How am I able to store the program on the DS so I dont have to program it everytime?
|
|
#2
|
|||
|
|||
|
Re: How to store a program on the Drive Station?
In chapter four of the FRC Programming guide at ni.com/first they explain how to create a stand alone FRC Application, which will do what you want.
http://decibel.ni.com/content/servle...ming_Guide.pdf |
|
#3
|
|||
|
|||
|
Re: How to store a program on the Drive Station?
Teams cannot program the DS. They can only program the cRIO, a Dashboard and any custom circuits that they incorporate.
To program the cRIO and have it run an application at power-up (and hold that app over power cycles), refer to the doc linked to by mgurgol. Russ |
|
#4
|
|||
|
|||
|
Re: How to store a program on the Drive Station?
You should also bookmark the primary launchpad site for all such documentation.
http://www.usfirst.org/community/frc....aspx?id=10934 Russ |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drive Station Holder - What do you use? | Tanner | FRC Control System | 1 | 10-01-2009 00:35 |
| Problem Downloading Program from WindRiver to Driver Station | The_Laughing_ManMII | C/C++ | 10 | 09-01-2009 20:03 |
| How to conect solenoids to the circuit board. and how to program it...??? | arpitshah | Pneumatics | 6 | 13-01-2008 15:06 |
| How do you store / organize parts? | Dirty Harry | General Forum | 7 | 12-07-2004 00:40 |
| how to add steps in the provided encoder program for the edu | Zaramel2002 | Programming | 3 | 11-02-2004 08:35 |