|
|
|
 We're 3 pounds over. Drill until the hole saw is too hot to touch, then go find something else to cut off while you wait for it to cool down. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We're 3 pounds over. Drill until the hole saw is too hot to touch, then go find something else to cut off while you wait for it to cool down. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Devantech SRF08 Range Finder programming in LabView
Has anyone tried to implement the Devantech SRF08 Range Finder in Labview using the example provided for FRC. If so, what has been your experiences. Is the sensor reliable, have you been successful integrating control of the sensor in your FRC code?
|
|
#2
31-01-2009, 13:16
|
|||
|
|||
|
Re: Devantech SRF08 Range Finder programming in LabView
We have one but have not been able to get it or any other I2C sensors to return any data. Has anyone else had better luck using the I2C interface on the digital sidecars?
|
|
#3
31-01-2009, 20:17
|
|||||
|
|||||
|
Re: Devantech SRF08 Range Finder programming in LabView
I haven't tried the SRF08 yet. but I've used the I2C with the Hi Technic compass and the accelerometer without any trouble.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SRF05 Ultrasonic Range finder | yossi56 | Programming | 3 | 13-03-2008 16:48 |
| pic: range finder | falconmaster | Extra Discussion | 6 | 10-02-2008 22:49 |
| Ultrasonic Range Finder | nekng | Programming | 7 | 30-01-2008 23:00 |
| Using VEX range finder on the full-size FRC | CronosPrime1 | Programming | 3 | 08-02-2006 23:29 |
| Ultrasonic Range Finder | polyBot | Control System | 15 | 29-01-2006 12:46 |
Hybrid Mode
