|
|
|
 We can help FIRST improve the system, but we can't just blame them and wait. - Siri [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We can help FIRST improve the system, but we can't just blame them and wait. - Siri [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Bumper Height
What is the height range of how high the bumpers around the robot can be off the ground? (From the bottom of the bumper)
Thanks in advance. |
|
#2
20-01-2009, 16:08
|
|||
|
|||
|
Re: Bumper Height
This is a repost thread of mine a little while ago. They need to be on 5" tall vertical plywood between 1" and 7" inches from the ground.
|
|
#3
20-01-2009, 20:42
|
|||||
|
|||||
|
Re: Bumper Height
A BUMPER is 5" in height. It must remain in the BUMPER ZONE, which is a volume between two planes, 1" and 7" off the ground. Therefore the bottom of the BUMPER must be between 1" and 2" off the ground.
|
|
#4
20-01-2009, 23:57
|
||||
|
||||
|
Re: Bumper Height
Direct from page section 8.2 (page 4) "Bumper Zone - The volume contained between two viryual horizontal planes, one inch above the floor and seven inches above the floor" Soo.. there can only be a 1" from the floor to the bottom of the bumper. And the bumper top can only be 7" from the floor to the top of the bumper.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bumper Height? | EricVicenti | Rules/Strategy | 9 | 14-01-2009 12:23 |
| Height of overpass | Evert | General Forum | 8 | 07-01-2008 14:11 |
| Bar Height | Paul H | Rules/Strategy | 3 | 10-01-2004 19:28 |
| Bar Height | DuDaKyD | General Forum | 11 | 09-01-2003 22:54 |
| Railing height | archiver | 2000 | 1 | 24-06-2002 00:17 |
(since 2004)
Hybrid Mode
