|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Hello, here is my situation... i am using windriver and i download code to the robot, and reboot and then it says no code..... i try the same exact code, without any code for relays in it, and it works. I can build both codes with no errors. What am i doing wrong? Please help... thank you.
|
|
#2
|
|||||
|
|||||
|
Re: Why is it telling me no code....
Make sure both your cRIO and your Workbench/LabView are updated to the most recent version.
|
|
#3
|
||||
|
||||
|
Re: Why is it telling me no code....
they are, i updated the cRIO to v7, and windriver workbench to update number 3... any other possibilities?
|
|
#4
|
|||||
|
|||||
|
Re: Why is it telling me no code....
The cRIO needs to be at version v11 in order to work with update #3. v7 was the firmware for update #2.
|
|
#5
|
||||
|
||||
|
Re: Why is it telling me no code....
oh ... i didn't see that update, thank you very much! Good Lucky this season =]
|
|
#6
|
|||||
|
|||||
|
Re: Why is it telling me no code....
No problem - happy programming.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Telling drivers station your alliance | Mike Mahar | FRC Control System | 5 | 17-01-2009 08:43 |
| Any reason why EEPROM code forgets after power off. | PhilBot | Programming | 0 | 31-01-2008 15:09 |
| Telling alliance in the code | Andrew Schreiber | Programming | 4 | 30-01-2008 10:30 |
| Why should I update my 2006 code? | amateurrobotguy | Programming | 4 | 09-01-2007 21:09 |
| Pact of Secrecy (Stop Telling US!) | Joe Matt | Rules/Strategy | 17 | 30-01-2002 01:02 |