help with Compressor and labview

Team2883 · #1 28-01-2009, 21:53

We have the solenoid configured and have a program that works, we think. We would like to try and hook up the compressor to a spike relay. How do you wire the electrical for the spike to the compressor and back to the DSC? please help, thank you

~ Fighting Rednecks ~

rfolea · #2 28-01-2009, 22:04

Just connect a PWM cable (the Black/Red/White one) between the Spike and the DSC.

Team2883 · #3 28-01-2009, 22:08

ok, thank you for the help its much appreciated

~Fighting Rednecks~

Team2883 · #4 28-01-2009, 22:15

The led is red on the spike relay but the power just runs right through it...how do we stop this situation?

Russ Beavis · #5 28-01-2009, 22:18

http://www.usfirst.org/community/frc....aspx?id=10934

Please check out the Power Distribution Diagram and Data Connectivity Diagram before proceeding. You really need to print these out and keep them handy.

Russ

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need help with Festo Solenoid and Labview	Team2883	General Forum	3	17-02-2010 12:56
1482 Help with Compressor	Rinaldi 427	General Forum	7	31-01-2007 07:46
Labview and communication with peripheral device help	jaijaidin	LabView and Data Acquisition	3	26-01-2007 19:17
somebody help me with my compressor please	royboards05	Pneumatics	4	19-02-2005 00:38
Help With Compressor Code	fred	Programming	6	21-01-2005 17:40