p60 gearbox disassembly

KNZ1030 · #1 28-01-2009, 22:25

Chief delphiers-
My team and I recently ordered a p60 banebox gearbox and cannot figure out how to get it apart to grease the inside. Any pointers would be greatly appreciated.
Thanks!

sdcantrell56 · #2 28-01-2009, 22:32

All you do is undo the 4 bolts through the face. Banebots said that it might be a tight fit and that you just pull until it separates after you have removed the bolts.

We just got 4 in today and hopefully we will start testing them in the next few days. So far they look exponentially better than the 36/42mm banebots

Ceal Craig · #3 31-01-2009, 20:36

We are looking at using the P60 gearbox with the Mabuchi motor in the KOP or possibly the Fisher-price motor itself from the KOP (without its gearbox).

Is that correct? we are a little confused right now whether both motors will work with it?

Richard McClellan · #4 31-01-2009, 21:17

Yes, you can use either the rs545 motor or the fisher price motor with the P60 gearbox. The shaft on the fisher price motor does need to be cut a little shorter, but other than that it works great.

Ceal Craig · #5 02-02-2009, 11:07

Thanks so much -- appreciate the quick reply!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
P60 planetaries gearboxes	Rosiebotboss	Motors	25	24-05-2009 00:57
Gearbox pt 2	bobdahaxor	Technical Discussion	14	22-12-2007 11:24
Gearbox	bobdahaxor	Technical Discussion	1	13-12-2007 19:34
Offseason gearbox project... maybe this gearbox has helical gears?	Travis Covington	Technical Discussion	17	05-06-2006 11:48
Gearbox	ZACH P.	Motors	4	09-02-2003 20:14