control 4 motors in autonomous?

pinballwizard96 · #1 09-02-2009, 18:48

We have 4 motors controlled in teleoperated (2 per joystick), but are confused about controlling more than 2 in autonomous because there seems to be no motor selection...would inserting one work or just cause the code to fail?
Thanks

Mike Betts · #2 09-02-2009, 19:10

All robot functions are available in autonomous. Only the operator station inputs are not available in this mode.

Luke Pike · #3 09-02-2009, 20:26

Quote:

Originally Posted by Mike Betts

All robot functions are available in autonomous. Only the operator station inputs are not available in this mode.

Does this mean that I can't have an autonomous mode switch on the DS? We were going to have it on the robot, but we needed the digital inputs for sensors. I read somewhere that you can still monitor inputs during the disabled portion of the match, is this still true?

Mike Betts · #4 09-02-2009, 21:28

Quote:

Originally Posted by Luke Pike

Does this mean that I can't have an autonomous mode switch on the DS? We were going to have it on the robot, but we needed the digital inputs for sensors. I read somewhere that you can still monitor inputs during the disabled portion of the match, is this still true?

Luke,

That is true. However, you have to latch the input in during disabled because those same DS inputs will become unavailable in Autonomous Enabled.

Please read this thread.

Regards,

Mike

Luke Pike · #5 10-02-2009, 12:03

Thanks Mike!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Autonomous and Operator Control modes	mjbshaw	Programming	4	14-02-2008 18:13
pic: Autonomous Control Sample	Squall	Extra Discussion	4	07-04-2005 01:53
OI/Control Board LEDs during Autonomous	ace123	Programming	1	12-02-2005 19:38
Using pressure pad to control during Autonomous	ttedrow	Rules/Strategy	8	18-01-2005 23:57
Autonomous to Manual control?	Lint_Ninja	Programming	5	16-02-2004 21:48