|
|
|
 Begging, yelling, kicking, and screaming for members of my team to send me updates while I'm at college not doing homework. - Ginger Power [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Begging, yelling, kicking, and screaming for members of my team to send me updates while I'm at college not doing homework. - Ginger Power [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
10-02-2009, 20:25
|
||||
|
||||
|
Re: 2 Motors 1 Jaguar
No, you can't because its a hazzard
because there are two motors, theres double the current and it could mess up your electronics |
|
#3
10-02-2009, 20:43
|
|||||
|
|||||
|
Re: 2 Motors 1 Jaguar
No
<R48> Each power-regulating device (speed controller or relay module) shall control one and only one electrical load (motor, actuator or compressor). |
|
#4
11-02-2009, 08:08
|
|||||
|
|||||
|
Re: 2 Motors 1 Jaguar
However, in another thread, Erik Van Wyk has reported that you can connect two Jaguars or two Victors to the same PWM cable using a "y" adapter cable. That would allow you to control two motors through two controllers with a single control output.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jaguar Meltdown | Peter H | Electrical | 47 | 05-04-2010 17:44 |
| Jaguar retailers | mutantblond | Electrical | 1 | 30-01-2009 13:18 |
| Jaguar Failure | Nightfall831 | Electrical | 8 | 21-01-2009 10:12 |
| Jaguar Fried? | Sovietmagician | FRC Control System | 0 | 19-01-2009 23:27 |
| Jaguar deadband? | skidmarks | Motors | 1 | 06-01-2009 22:53 |
Hybrid Mode
