|
|
|
 Gracious Professionalism, it's hard to describe, but I sure know when I'm not living up to it. - rsisk [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Gracious Professionalism, it's hard to describe, but I sure know when I'm not living up to it. - rsisk [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
|||
|
|||
|
How to program sonar
Our Team is using the LV-MaxSonar-EZ3
We are having a lot of trouble programing for the sonar. Can anyone post some C ++ code that uses the sonar. As far as I have seen there is no sample code for the sonar. Thanks a lot  Last edited by FearlessLeader : 02-11-2009 at 04:26 PM. 
|
|
#2
02-11-2009, 10:39 PM
|
||||
|
||||
|
Re: How to program sonar
It depends on how you have it wired. I am guessing you are using analog?
If so use the AnalogChannel class and use the AnalogChannel::GetVoltage() to get your voltage and multiply that value accordingly (a value you can find in the EZ3 datasheet)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to program phneumatics? | Skyman7 | NI LabVIEW | 4 | 02-05-2009 04:21 PM |
| How to conect solenoids to the circuit board. and how to program it...??? | arpitshah | Pneumatics | 6 | 01-13-2008 03:06 PM |
| How NOT to program | wun | Programming | 10 | 11-08-2004 03:34 PM |
| How to program servos | bstempi | Programming | 7 | 02-24-2004 01:45 PM |
Hybrid Mode
