Need help with CMUCam video out

steve d · #1 01-11-2009, 19:11

Can't get a steady picture out. None of my monitors can sync onto the signal. I connected the video out to a small personal video player with NTSC/PAL video input. The picture is scrambled like no horizontal sync. No help with video player in either mode, PAL or NTSC. I did not switch the camera into YCrCb mode, cause I don't know how. Can someone tell me how to get a good picture onto a monitor?

Kevin Watson · #2 09-11-2009, 23:23

Quote:

Originally Posted by steve d

Can't get a steady picture out. None of my monitors can sync onto the signal. I connected the video out to a small personal video player with NTSC/PAL video input. The picture is scrambled like no horizontal sync. No help with video player in either mode, PAL or NTSC. I did not switch the camera into YCrCb mode, cause I don't know how. Can someone tell me how to get a good picture onto a monitor?

I got it to work a few years ago and I think it's just a matter of switching to YCrCb mode. I haven't looked at the camera code in a while, but it should be documented in the camera initialization code.

-Kevin

steve d · #3 07-11-2009, 20:50

No,but I haven't given up. Do you have the same problem?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
hi dear cmucam testers (need help)	Lawrey	Programming	2	24-08-2007 19:03
Branching out -- I need some help getting started!	kitscuzz	Programming	5	25-02-2007 23:35
Need a little help with how to break out of the box	amateurrobotguy	Programming	6	16-01-2006 12:56
hey need some help with writing a code please help me here	magical hands	Programming	9	01-01-2004 21:46
Still need video help...	soap108	General Forum	0	24-03-2003 01:03