|
|
|
 Mmmmmmmm. Donuts! - Sean Schuff [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Mmmmmmmm. Donuts! - Sean Schuff [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
R07-Bumper configuration legality
according to R07
"BUMPERS must provide complete protection of the entire FRAME PERIMETER of the ROBOT (i.e. BUMPERS must wrap entirely around the ROBOT). The BUMPERS must be located entirely within the BUMPER ZONE when the ROBOT is standing normally on a flat floor, and must remain there (i.e. the BUMPERS must not be articulated or designed to move outside of the BUMPER ZONE)." so is this design legal? http://i844.photobucket.com/albums/a...g?t=1263166036 Assuming the Blue are bumpers, all are at least 6 inches, and the indentation is 3 inches. |
|
#2
10-01-2010, 18:36
|
||||
|
||||
|
Re: R07-Bumper configuration legality
Quote:
So no, not legal, since it does not wrap entirely around the robot. No gaps are allowed. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| <R07> F -source for bumper fabric? | Andy Brockway | Rules/Strategy | 9 | 12-01-2010 07:36 |
| Your opinion: does our mesh violate rule R07?? | RoboMaster | Rules/Strategy | 9 | 16-02-2009 18:46 |
| paper: Bumper Legality Flow chart | XXShadowXX | Extra Discussion | 4 | 30-01-2009 19:01 |
| pic: 397 Bumper Configuration | Andrew Schreiber | Extra Discussion | 24 | 18-01-2009 12:29 |
| pic: Legal Bumper Configuration? | AdamHeard | Extra Discussion | 31 | 15-01-2009 03:15 |
Hybrid Mode
