|
|
|
 Dean will make America gracious again - seth.brugler [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Dean will make America gracious again - seth.brugler [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
I/O Board Cannot Connect
We have successfully programmed our I/O Board, using our Classmate, but our Driver Station has been unable to detect it. We haven't tried connecting any switches or anything to the board. Does it need to have something hooked up in order for it to be detectable? Any suggestions on how to resolve this problem would be greatly appreciated.
Last edited by Haragorn : 13-01-2010 at 17:39. 
|
|
#2
14-01-2010, 12:43
|
|||
|
|||
|
Re: I/O Board Cannot Connect
Nothing needs to be hooked to it to be detected.
If you look in Device Manager under USB, do you see the board? If so, is it listed as unconfigured? Did you cancel out of a New Hardware Found wizard? Please give more information. -Joe
|
|
#3
14-01-2010, 13:50
|
|||||
|
|||||
|
Re: I/O Board Cannot Connect
You need to either apply the latest PS0C update, or reinstall the PS0C software.
http://www.chiefdelphi.com/forums/sh...threadid=80102
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cypress IO board connect | SteveD | FRC Control System | 12 | 16-01-2010 16:46 |
| Cannot connect to the Real-time target | Mr. E | FRC Control System | 13 | 02-02-2009 20:47 |
| Cannot Connect to Axis Camera Wirelessly | computerish | Technical Discussion | 4 | 11-01-2009 19:19 |
| Cannot Program RC | kokodabear | Electrical | 4 | 29-11-2006 17:29 |
Hybrid Mode
