[FTC]: How to run servos with LABview?

Using an FTC Tetrix Kit to build our robot, then program it with LABview we were able to run our motors. Now the problem is that when we try to modify the VI's to run our servos that control the rest of our automated parts of the robot, we are unable to make them move. The only movement we have seen them make was a twitch when we plugged them in so we know the connection is there and the servos are working. We have tried switching our daisy chain with the motors around, but to no avail. We tried motor configuring a few times and we have yet to see any improvement. Any suggestions?

Here's a (badly-editted) picture of our VI from imageshack: http://img18.imageshack.us/img18/6198/firsttech.jpg