How do you wire the ADXL354 Accelerometer?

AustinGra · #1 23-01-2010, 11:25

Can anybody explain how to wire the ADXL345 Accelerometer Board or can someone provide a wiring diagram? Thanks.

erichahn525 · #2 23-01-2010, 12:30

Because the Accelerometer is a digital sensor, your going to wire it into the digital side car. You're going to preferably solder 4 pins into "OV, SDA, SCL, and 5V" then use female to female wires to connect it to the side car. The pins on the side car are next to the I2C (the small gray box). 5v on accel connects to 5v on side cart, SCl on acel connects to SCL on side cart, SDA connects to SDA on side cart, and finally OV connects to (-) on side cart. I hope all this helps

DonRotolo · #3 23-01-2010, 20:39

Don't solder to the Digital Sidecar; use a connector.

Details of what connects to where are in the Sensor Manual, found on the FIRST web site.

PingPongPerson · #4 11-02-2010, 19:47

This was very useful, thanks. Do you also know how to wire the connected gyro? We are stuck trying to figure this out.

Alan Anderson · #5 11-02-2010, 23:33

Listen to Don.

Quote:

Originally Posted by Don Rotolo

Details of what connects to where are in the Sensor Manual, found on the FIRST web site.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do you wire up the Operator Interface?	iPilipino	Electrical	6	22-01-2008 00:22
How do you wire the gear tooth sensor?	1594code	Electrical	5	12-01-2008 16:24
How do you wire the wheel encoders?	Demothesis	Electrical	2	17-07-2007 16:59
how do you wire the team light	coolguybigt	Robot Showcase	2	21-02-2007 22:18
how do you mount the accelerometer?	team 507	Control System	4	10-02-2005 07:54