|
|
|
 Often heard exchange in the shop: "The physics don't allow that." "But it's so cool!"
- MBF [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Often heard exchange in the shop: "The physics don't allow that." "But it's so cool!"
- MBF [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
how to set up 206 axis cam in labview
our team is in a hard spot we need to figure out how to setup the axis 206 cam in labview we dont know how but we need to figure it out any help would be awsome on how to get the software and the cam to work together
|
|
#2
02-02-2010, 15:38
|
|||||
|
|||||
|
Re: how to set up 206 axis cam in labview
You should first connect the cam to your computer via a crossover cable. Then, run the Axis Cam Setup Tool, it will setup the cam's IP address and passwords. This must be done or the camera driver will not be able to find the camera.
Then, you should plug the camera in to port 2 on the cRio. The code necessary to track a target is shown in the default code. You should be able to use it without too much work. Reading over it will explain how the camera software works. |
|
#3
02-02-2010, 16:00
|
|||||
|
|||||
|
Re: how to set up 206 axis cam in labview
Everything you need to know is in the FRC Control System documentation. The http://www.usfirst.org/frccontrolsystem web page has links to each chapter. You must read chapters 1-3 in order to know how to use the control system effectively.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set up 206 axis cam in labview | team3323 | General Forum | 0 | 02-02-2010 15:23 |
| Axis 206 cam frame rate | yoavh360 | Electrical | 11 | 23-01-2010 21:45 |
| AXIS 206 camera not working | Wicked | NI LabVIEW | 3 | 21-01-2010 10:05 |
| Axis Cam brightness in LabView | Chath Maral | Programming | 3 | 07-02-2009 19:47 |
| Anyone know how to get a live video feed from your axis cam? | Jazonk | FRC Control System | 7 | 03-01-2009 20:08 |
Hybrid Mode
