|
|
|
 I think that everyone should just take a step back and look at the whole picture, FIRST is a family, not an organization full of regions, we all try to help each other, not 'cause it benefits us, but because it's graciously proffesional. - Mike Schroeder [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
06-02-2010, 02:00
|
|||
|
|||
|
Re: Disappearing Robot Code
Does the Dashboard say "No Robot Code" from time to time when you're using some specific piece of hardware? We had this problem and we hypothesized that the code was too bulky and there was too much output. We fixed the problem when we cut down on console outputs and watchdog usage.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compressor Code causes No Robot Code Error | sircedric4 | C/C++ | 25 | 03-02-2010 10:13 |
| Events marked as Attending not disappearing after they end | Elgin Clock | CD Forum Support | 9 | 04-03-2008 23:23 |
| Robot Code? | leftylink | Programming | 0 | 18-02-2008 14:34 |
| Inventor:Disappearing grid and drawing | JoeXIII'007 | Inventor | 7 | 11-06-2005 18:28 |
| Weird Disappearing Commands | Orborde | Programming | 5 | 19-04-2005 19:20 |
Hybrid Mode
