Vision target mounting

rath358 · #1 13-02-2010, 22:09

After extensive puzzling and asking around, I am at a loss about the vision targets. Which side of the plexiglass will they be on? The manual says it is on the plexiglass, but that is pretty ambiguous. Does anyone know?

DonRotolo · #2 13-02-2010, 22:26

One would speculate that it'll be mounted to the back of the plastic, to protect it, but I'm not exactly sure how this might affect our robot's ability to "see" it, if at all.

jamie_1930 · #3 13-02-2010, 23:18

Quote:

Originally Posted by rath358

After extensive puzzling and asking around, I am at a loss about the vision targets. Which side of the plexiglass will they be on? The manual says it is on the plexiglass, but that is pretty ambiguous. Does anyone know?

I'm unclear on what the answer is, although my guess is the same as Don's, but I am curious to what you think the differences this will cause are.

rath358 · #4 13-02-2010, 23:19

Quote:

Originally Posted by jamie_1930

I'm unclear on what the answer is, although my guess is the same as Don's, but I am curious to what you think the differences this will cause are.

having the plexiglass in front would cause a lot of glare.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Vision Target!!!	Pancake	Programming	4	22-01-2010 14:30
Durability of Vision Target	geeknerd99	General Forum	13	11-02-2006 14:15
Vision Target Assembly	platt	Kit & Additional Hardware	4	26-01-2006 17:34
vision target	Dakota Snow	Kit & Additional Hardware	1	08-01-2006 23:00