|
|
|
 Yes, machining a dog profile into a steel sprocket on a manual mill was an experience filled with pain and regret. - Joe G. [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yes, machining a dog profile into a steel sprocket on a manual mill was an experience filled with pain and regret. - Joe G. [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
cRIO-sidecar communication
We are having problems communicating between the cRIO and sidecar, it was working before but now it isn't.
The signal light isn't lighting and the Jaguars aren't responding to the sidecar either. Team 3089 |
|
#2
21-02-2010, 21:04
|
|||||
|
|||||
|
Re: cRIO-sidecar communication
Noah,
It sounds like the power supply wiring may have a problem. Did a wire pull out of the connector? Did someone remove the circuit breaker? Is it possible that you are not communicating with the robot? |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| digital sidecar J1 pinouts (cRIO connection) | stevethetinker | Programming | 0 | 09-02-2010 21:34 |
| Changing Crio Digital Sidecar input slot from slot 4 to 5 | Trevor_Decker | Java | 9 | 28-01-2010 12:29 |
| Netbeans 6.8 Ftp to cRIO communication issue | mark.amber | Java | 4 | 20-01-2010 17:10 |
| Sidecar Debug | NinjaSpawn94 | NI LabVIEW | 6 | 07-02-2009 10:48 |
| Digital Sidecar Resistor | NinJA999 | Electrical | 5 | 30-01-2009 19:53 |
Hybrid Mode
