|
|
|
 But no matter how you place, the thing to watch for is the character change in the team members. The trophies are only important for a few hours. The character that is built will last a lifetime. - BrothersKeepers [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
I2c port questions
Is there any documentation on how to use the i2c port on the digital sidecar? I have been trying to program an ultrasonic sensor to give us a readout on our driverstation (as a user message) but so far when I run the code I only get a readback of zero. I was told there are examples on how to program the i2c port In labview, but I can't find them; can someone help it a little?
The sensor is a SRF08 ultra sonic range finder, and all of the documentation we have for it we got from http://www.acroname.com/robotics/parts/R145-SRF08.html Thanks! |
|
#2
27-08-2010, 10:30
|
|||||
|
|||||
|
Re: I2c port questions
Some sample I2C uses are under Examples More...
From the LabVIEW Getting Started screen go to the bottom right under Examples and click More... Then look at the two examples:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiple I2C sensors | ajd | Sensors | 7 | 20-02-2011 00:55 |
| i2c output | virtuald | Programming | 16 | 18-01-2009 19:20 |
| I2C tutorials | John Gutmann | Electrical | 3 | 30-07-2005 10:44 |
| I2C? | John Gutmann | Electrical | 3 | 19-07-2005 22:52 |
| TTL port to a serial port on a demo board | ImmortalAres | Programming | 16 | 09-07-2005 23:44 |
Re: I2c port questions
Hybrid Mode
