|
|
|
 If you see Navy ships in port, you're going to be fine. If you see ships pulling out, or no ships at all, go East. Fast. - Matt Howard [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| If you see Navy ships in port, you're going to be fine. If you see ships pulling out, or no ships at all, go East. Fast. - Matt Howard [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
||||
|
||||
Andy Mark Tough Box
We have gotten a new Tough Box and it came with a hex shaft. It is impossible to put the bearing on it. We have studied the video and searched the internet, but couldn't find a solution. Can anybody help?
|
|
#2
26-10-2010, 19:59
|
|||
|
|||
|
Re: Andy Mark Tough Box
You can buy Hex bore bearings here. http://www.andymark.com/SearchResults.asp?Cat=239
|
|
#3
26-10-2010, 20:09
|
||||
|
||||
|
Re: Andy Mark Tough Box
Check what you ordered. They sell both keyed and hex versions.
If they sent the wrong thing, give them a call http://www.andymark.com/SearchResults.asp?Cat=177. If you ordered the wrong thing you can just order the correct shaft. http://www.andymark.com/searchresults.asp?cat=224. |
|
#4
27-10-2010, 08:45
|
|||||
|
|||||
|
Re: Andy Mark Tough Box
AndyMark also sells hex bearings and hubs that fit the ToughBox output shaft.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: Mounting the andy marks tough box to the kit box | SwindyWBcapt | OCCRA Q&A | 1 | 05-10-2009 16:18 |
| [OCCRA]: Tough Box | bgod1221 | OCCRA Q&A | 1 | 02-10-2009 09:49 |
| AndyMark Tough Box? | Waffle | Kit & Additional Hardware | 8 | 19-01-2009 18:20 |
| Tough Box with 2 CIM's | Andrew Y. | Motors | 8 | 12-02-2008 08:57 |
| Andy Mark (reliable???) | cobrawanabe1699 | Technical Discussion | 31 | 15-01-2008 12:55 |
Hybrid Mode
