|
|
|
 The thrills of a heroic repair, a well deserved award, a compliment on our efforts, the growth of our team members, making new friends.... These can make a memorable and exciting FIRST regional as much as a close match. - Mark Pierce [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
Parallax servo speed
Does anyone have spec's on the rated (no load) speed for the Parallax 180 degree servos that Digikey carries? I don't see it on the data sheet. I just sent them a note to ask for it.
|
|
#2
25-01-2011, 09:29
|
|||
|
|||
|
Re: Parallax servo speed
I believe they are (or at least used to be) mostly a standard Futab servo. Maybe take a look at the specs for a Futaba standard servo?
|
|
#3
25-01-2011, 11:07
|
||||||
|
||||||
|
Re: Parallax servo speed
Just got a note back from Parallax with the answer 5 MPH
 I called them and they said it is a Futaba S148 servo; Futaba shows that to be 0.22 seconds per 60 degrees, so with torque at 41.7 oz-in it works out to about 1.4W. |
|
#4
03-02-2011, 14:36
|
||||||
|
||||||
|
Re: Parallax servo speed
Question for the LRI's:
I can show documentation for the specs on the Futaba S148 servo - they are available on their website. I have the word of Dave Andreae at Parallax Tech Support (over the phone) that their 900-00005 servo is a Futaba S148 servo. I don't have anything in writing to that effect, and I don't see any markings on the servo that indicate that. If I sign our sheet that says we built the robot within the rules, is that sufficient to close the loop on documentation? |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
