|
|
|
 We're not disappointed if we don't achieve excellence, so long as we did everything we could in our pursuit of it. - JVN [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We're not disappointed if we don't achieve excellence, so long as we did everything we could in our pursuit of it. - JVN [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Banebot 775 versus FP motor
Anyone have any good comparision data of the 775 running at 12v compared to the FP motor ?
Last edited by de_ : 30-01-2011 at 14:32. |
|
#2
30-01-2011, 13:39
|
||||
|
||||
|
Re: Banebot 775 versus FP motor
Attached is the motor curves data sheet from the FIRST website.
hope it helps. |
|
#3
30-01-2011, 13:59
|
||||
|
||||
|
Re: Banebot 775 versus FP motor
Quote:
...or this one. Last edited by Ether : 30-01-2011 at 14:01. |
|
#4
30-01-2011, 16:28
|
||||
|
||||
|
Re: Banebot 775 versus FP motor
yeah its 18v but the motor is still run at 12v, the motor running at 12v is what is in the data sheet
|
|
#5
30-01-2011, 16:43
|
|||||
|
|||||
|
Re: Banebot 775 versus FP motor
Quote:
|
|
#6
30-01-2011, 16:49
|
||||
|
||||
|
Re: Banebot 775 versus FP motor
Yes, it was updated on the 26th
|
|
#7
30-01-2011, 16:55
|
||||
|
||||
|
Re: Banebot 775 versus FP motor
Has anyone here measured the locked-rotor inductance for the RS775, or seen a spec for that anywhere? If not, how about scope traces of the locked-rotor motor current when running with the Jag at low duty cycles (like say 20% or so). |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
