|
|
|
 Excuse me while I rant on your comment here a bit. - Andrew Remmers [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Excuse me while I rant on your comment here a bit. - Andrew Remmers [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Jaguar - Speed controlling 2 motors
So we have two motors tied together in a transmission. We have an encoder attached to the output shaft from transmission.
We want to use the Jag/CAN control with PID to set speeds for these two motors. How can we do that in Labview without the two Jaguar's fighting each other? 
|
|
#2
03-02-2011, 20:48
|
||||||
|
||||||
|
Re: Jaguar - Speed controlling 2 motors
The following thread had several ideas, but there are still experiments to be run. http://www.chiefdelphi.com/forums/sh...ad.php?t=89282
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
