|
|
|
 Aha I just noticed you're from my team.
--Petey - Petey [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Aha I just noticed you're from my team.
--Petey - Petey [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Servo Motor Issues
We used the sample servo code, and it's not working. We've wired correctly, following the schematics. The signal output doesn't send a pulse at all. Please help.
|
|
#2
03-02-2011, 23:16
|
||||
|
||||
|
Re: Servo Motor Issues
Hey, I'm not a programmer or electrical guy but we were having the same issue and we found out that all you need is a jumper connecting the 2 pins next to where you plug the servo in on the side car. The servo runs on 6 volts and the pwm pins only give 5 volts (I think). It was kinda funny because we thought that every servo we had was somehow defective. We literally tested like 7 servos.
Hope that helps and good luck to you and your team! Last edited by NyCityKId : 03-02-2011 at 23:24. |
|
#3
04-02-2011, 00:20
|
||||
|
||||
|
Re: Servo Motor Issues
Post the begin.vi code. Also, make sure you wired up BOTH of the attachments to the digital sidecar (power and data) and you put the jumper in.
|
|
#4
04-02-2011, 08:47
|
||||
|
||||
|
Re: Servo Motor Issues
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
