|
|
|
 "So we have an arm, and the pot on it tells how high we are...
...and then we know how high we want to be...
...and if we're not high enough we go higher."
(I have to leave the room, we're all laughing too much.) - demosthenes2k8 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Codding Pneumatics with C++
We are a rookie team this year and are planing on using pneumatics which we know very little about. We have found tons of resorces on how to set up the acctual system but none on programing in C++. If anyone could give us tips, sample code or point us in the right direction that would be great.
Cheers |
|
#2
13-02-2011, 13:03
|
||||
|
||||
|
Re: Codding Pneumatics with C++
Well you would need at the least code to tell compressor to start/ turn off and program in a pressure switch along with the compressor, and solenoids to turn on and off. I don't use C++ for FRC however.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
