[C++] CAN cRio image problem

[wt200999]

After updating all of the jaguars and the cRio with the black firmware option, our cRio freezes right after it displays that it loaded the Black Jaguar program (and says it was built from SVN revison 60). In order to do anything else I have to change the configuration in Safe Mode. Once I take off the black jaguar option the cRio works fine.

I know all of my jaguars are updated and working since they all work in BDC-COMM.

[jhersh]

Can you verify that you have the cRIO Image v25 installed?

[ozrien]

I've seen this symptom when using the Black Jaguar plugin and I forgot to disable the console out dip switch on the cRIO. Could this be the problem?

[Alan Anderson]

Originally Posted by wt200999

...our cRio freezes right after it displays that it loaded the Black Jaguar program...

Where does it display this?

Originally Posted by ozrien

I've seen this symptom when using the Black Jaguar plugin and I forgot to disable the console out dip switch on the cRIO. Could this be the problem?

Good point. The console output goes to the same port as the messages intended for the Black Jaguar serial-to-CAN conversion.

[jhersh]

Originally Posted by ozrien

I've seen this symptom when using the Black Jaguar plugin and I forgot to disable the console out dip switch on the cRIO. Could this be the problem?

Were you guys able to verify that this was happening to you?