RS775 Gearboxes

[thefro526]

Originally Posted by Brandon Holley

Yeah hopefully they are doing that, however anyone can throw out lead times like that to cover themselves, but that's a place I will always be cautious about getting parts on time from. I will just take a "wait and see" outlook until I start hearing from teams on actual timing.

-Brando

I'll try and report back with whatever news I get as soon as I get it.

Originally Posted by Chris is me

I was under the impression that the P60s were counterintuitively stronger than the P80s. If the P60s can output less than 85 ft-lbs of torque, they're pretty much completely useless to me.

Banebots has posted that the P60 transmissions aren't recommended to output more than 35-ft lbs of torque. Anyone who's looking at purchasing either the 64:1 or the 256:1 Transmission should be aware that it is theoretically possible to exceed this torque with an RS775 (I would assume 500 series motors as well, but I haven't run the numbers) at Full Stall so design accordingly...