|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: pic: Shaker 2011 Arm Gearbox (Maybe?)
For high reduction arms, depending on how they are loaded, it's possible the motor never even comes near stall torque, so aluminum may work fine.
Also, if you space your plates 1.125 apart, you can make this same gearbox with ZERO custom shafts, and the use of no spacers, by utilizing the toughbox and cimple box gears. It's a trick we've been using for three seasons now. |
|
#2
|
||||
|
||||
|
Re: pic: Shaker 2011 Arm Gearbox (Maybe?)
I did try and use all Toughbox custom shafts, but with the compound gear reduction a wider gearbox was needed to prevent gears from meshing with multiple stages.
![]() However I think I'll try and use gears with different center-center distances to try and get away with TB shafts. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|