|
Re: Banebots gear boxes in CAD?
If you're talking about the P60s, there's a couple of models on 3dcontentecentral:
http://www.3dcontentcentral.com/down...=171&id=208143
http://www.3dcontentcentral.com/down...=171&id=171413
The only difference between the reductions is the lengths, which you can from this datasheet:
http://banebots.com/docs/P60A-DATASHEET.pdf
In Autodesk Inventor, you can use Thicken/Offset to make the necessary changes, not sure what the appropriate tool would be in other packages.
--Ryan
__________________
FRC 2046, 2007-2008, Student member
FRC 1708, 2009-2012, College mentor; 2013-2014, Mentor
FRC 766, 2015-, Mentor
|
You can sometimes step outside the box if you have properly thought through the question. - Jim Zondag [more] 
22-01-2011, 20:21
Threaded Mode