Switching from Autonomous to Tele-op

Remember to drive it like you stole it but be sure that it is in OVERDRIVE. - Steve W [more]

		Chief Delphi > Technical > Control System
Switching from Autonomous to Tele-op

Thread Tools

Rate Thread

Display Modes

#14

22-01-2011, 22:59

Ethan Spitz Ethan Spitz is offline

President

FRC #3637 (The Daleks)

Team Role: Leadership

Join Date: Feb 2009

Rookie Year: 2011

Location: New Jersey

Posts: 133

Ethan Spitz is an unknown quantity at this point

Re: Switching from Autonomous to Tele-op

Ok

I'm a little confused, when I code the closes, do I need to make references to them in the autonomous mode or tele-op mode, or do I just use the get reference and then close, and never use set reference in the tele-op or autonomous vi's

Ethan

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:11.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.