LabVeiw Code Deployment

[Team#2057-Vegas]

we're having the same problem.. the exact same thing as you except ours is showing code but when we start teleop or autonomous.. nothing happens! it'll run but our joysticks and buttons do nada

[riptide]

Build project
Run as startup
Reboot does not seem to work that well from labview
Reboot from the driver station under diagnostics tab (I think)
Wait for a few until you get communication and Robot Code

Hope this helps

[plnyyanks]

also, make sure you read the dialog box during deployment. If, when it's finished and waits for you to click a button (i forget which), it says "deployment completed with errors" then it didn't work. Simplest troubleshooting for this would be cold reseting the cRIo and trying again.