|
|
|
 Don't just assume that because you can modify an existing design that you are an engineer. - Daniel_LaFleur [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't just assume that because you can modify an existing design that you are an engineer. - Daniel_LaFleur [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Camera Power Connector
Just to save a lot of guessing, has anyone found a source for the power connector for the Axis camera? We want to swap them back and forth between our practice robot and competition robot so the power adapter ones only solve half the problem.
I'm not looking for the whole power adapter, just the connector on the end. 
|
|
#2
27-01-2011, 21:05
|
|||
|
|||
|
Re: Camera Power Connector
No ideas on the power connector, but why not just put quick disconnects on the wires?
|
|
#4
27-01-2011, 21:28
|
|||||
|
|||||
|
Re: Camera Power Connector
It appears to me to be to be identical to last year's barrel connector.
Although Al insisted it wasn't in another thread. It does work. P.S. Talked with Al. It seems his old barrel connector is not the same as mine, so you need to verify your own. The outside barrel must be the correct fit, but also the inside center must not be loose (Al's issue) on the D-Link pin. Some barrel connectors have a larger center hole than others. The one we got with our Linksys in 2009/2010 has, in addition to the hole, a pair of spring contacts. Here's a comparison shot of one of the Linksys wall-warts that matches the D-Link. P.S. Sorry I mis-read and had the D-Link instead of the Axis camera on my mind. Last edited by Mark McLeod : 28-01-2011 at 14:05.
|
|
#5
28-01-2011, 12:02
|
||||
|
||||
|
Re: Camera Power Connector
I hadn't thought about putting connectors on the power cables...that's a good idea if we can't find the right connector. The extra connectors would be another source of failure but porobably not a big deal.
|
|
#6
28-01-2011, 12:37
|
|||||
|
|||||
|
Re: Camera Power Connector
Quote:
|
|
#7
28-01-2011, 14:01
|
||||
|
||||
|
Re: Camera Power Connector
We have several cameras on the robot, some a good distance from the PDB, so a connector closer to the camera would be in order.
Last edited by Dale : 28-01-2011 at 14:03.
|
|
#8
28-01-2011, 14:08
|
|||||
|
|||||
|
Re: Camera Power Connector
Quote:
|
|
#9
28-01-2011, 18:35
|
|||||
|
|||||
|
Re: Camera Power Connector
Let's see if I can't makeup for my previous way off topic post.
The Axis camera power connector appears to be a Radio Shack size "H" coaxial DC power plug. I have one of those universal power supplies with the interchangeable tips. Last edited by Mark McLeod : 29-01-2011 at 08:00.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
