PID need someone to look it over.

I don't miss the manufactured magic of Disney because Championships creates magic in itself; wherever the event may be held. - Erin Rapacki [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
PID need someone to look it over.

Thread Tools

Rating:

Display Modes

29-01-2011, 14:47

j.cole

Registered User

FRC #0379

Join Date: Jan 2010

Location: Girard

Posts: 159

PID need someone to look it over.

I have PID programed in but I'm not sure if its going to work and I cannot test it right now. What its doing is when a button is pressed (and held) it will turn one motor until it hits the setpoint then run another motor until it hits its setpoint. then stop. I don't know if it will work at all even in theory.

__________________

It's not normally a good idea to give a programmer a drill but rules are made to be broken.

Last edited by j.cole : 30-01-2011 at 13:51.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:16.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.