|
|
|
 "The hardest part about building the robot is figuring out what to build..." - Jeff Waegelin [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| "The hardest part about building the robot is figuring out what to build..." - Jeff Waegelin [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Bumpers
Does anybody know if at competition they are going to measure the robot with and without the bumpers? or just with them? can anybody tell us the dimensions that are required once it has the bumpers installed?
|
|
#2
29-01-2011, 17:13
|
||||
|
||||
|
Re: Bumpers
 and one more thing, uhhhhh, oh yes From my experience, during inspection you put your robot into a box with inner dimensions of 28x38x60 inches. The bumpers will be inspected but the size of the robot with them will not be measured. YMMV. |
|
#3
29-01-2011, 17:20
|
||||
|
||||
|
Re: Bumpers
The robot is measured and weighed without the bumpers installed. The bumpers are weighed and then inspected off and then on the robot. If you build the bumpers to the spec's in the rules you will be alright
 . |
|
#4
29-01-2011, 21:07
|
|||
|
|||
|
Re: Bumpers
Why is this in the programming section?
 |
|
#5
29-01-2011, 21:14
|
|||||
|
|||||
|
Re: Bumpers
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
- Arizona North
(since 2004)
Linear Mode
