|
|
|
 Only time will tell for sure, but it seems that the current software providers are hatching up a pretty good solution to the problem. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Only time will tell for sure, but it seems that the current software providers are hatching up a pretty good solution to the problem. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
31-01-2011, 18:40
|
|||
|
|||
|
Re: LabVIEW Encoder not reliably returning Rate
One thing that was discovered is that every other encoder works... so if you allocate one and ignore it and then allocate another one, you can use the built-in rate function. Naturally this means you have half as many that you can use, but if you don't need that many, this may be a good solution for you.
-Joe 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode