|
|
|
 Our team has a forum..... chiefdelphi.com Ok I had to say it. - Mike Martus [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Our team has a forum..... chiefdelphi.com Ok I had to say it. - Mike Martus [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Not enough pins =(
We were mapping out our control board for 2011 and we ran into a slight problem, we need more imputs than we have
 , does anyone know if we could possibly put 2 cypress first touch PSoC 5's, or if we could find another I/O board with more imputs??
|
|
#2
31-01-2011, 22:12
|
|||
|
|||
|
Re: Not enough pins =(
You can take the joysticks in the KOP apart and wire in your own buttons instead. Not the cleanest solution, but it works.
|
|
#3
31-01-2011, 23:17
|
||||||
|
||||||
|
Re: Not enough pins =(
The eStop Robotics CCI looks like a joystick to the driver station and allows you to attach your own buttons and analog sensors. http://www.estoprobotics.com/estore/...d&productId=33
It does appear that some people are having trouble with it, however. http://www.chiefdelphi.com/forums/sh...threadid=90529
|
|
#4
01-02-2011, 07:42
|
|||
|
|||
|
Re: Not enough pins =(
Have you switched the Cypress to the Enhanced mode already?
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
