pic: 3021 The Agency's Omni-Directional Mecanum

[hurtzmyhead]

Assuming these are only 2 wheels... if you could tilt the wheels on one set of rollers or the other it would make an interesting drive.

Our programer suggested that. Although a pneumatic system would be much quicker at changing directions, you still just have a omni directional drive. Now if you replaced on of the wheels with a plaction or other wheel, and actuated that up and down. Essentially it would be a different way of doing a Octocanum drive.

Those look like really high quality rollers! Were those purchased from some obscure secret warehouse or do you have a sponsor capable of advanced machining? (Presumably CNC mill, CNC lathe, and some custom hardware...)

Yep, between our two gracious sponsors HK Plastics and Aztec Tooling, we have 7 CNC mills, 1 CNC Lathe, 5 Manual Lathes, and 3 Drill Presses. we are spoiled. The Hub of the rollers used some fancy set ups on the Drill press/ Mill (didnt use a single CNC on them, and the students produced them). The Rollers were made on the CNC lathe.

On the "runs circles around West Coast Drive", you got any video? If you don't, I'm rather skeptical.

The circles part was a joke. We don't see how these wheels would work as shown in the picture, so were guessing that it will just go around in circles. Hopefully we'll have some footage up tonight.

What's the coolness factor for those wheels? OVER 9000!!

Im glad someone got that