Enhanced IO Error

[Mark McLeod]

I was just able to recreate this error on a different laptop.

Enhanced mode works on a Cypress connected to a Classmate, but the same board generates the error you're getting when connected to a different laptop (same cRIO).
I did test with different programming environments and it also happens in LabVIEW.

I haven't had time to investigate further yet, but it's almost certainly a PSOC software installation issue.
The Classmate had been wiped by the reimage, but the laptop just had C++ and LabVIEW uninstalled. The new PSOC software was installed overtop the old.
I'm going to try removing/uninstalling all the Cypress drivers, then reinstalling it.

[Joe Ross]

Originally Posted by Mark McLeod

I haven't had time to investigate further yet, but it's almost certainly a PSOC software installation issue.
The Classmate had been wiped by the reimage, but the laptop just had C++ and LabVIEW uninstalled. The new PSOC software was installed overtop the old.
I'm going to try removing/uninstalling all the Cypress drivers, then reinstalling it.

Team 1983 had the same issue and posted instructions http://www.chiefdelphi.com/forums/sh...ad.php?t=89739

[Mark McLeod]

Mine turned out to be just because the Cypress driver didn't start automatically.

• Start ->Control Panel ->Administrative Tools -> Services
• Look for CyMiniProg3Service and start it (if it isn't already running)
• Restart the Driver Station application

If it's already started or the previous steps don't get it recognized by the Driver Station application, then you do need to remove the old Cypress software and reapply the Driver Station Update.
You might be able to either uninstall all the Cypress software yourself or run the Driver Station Update and choose the Remove option for what you can, then run the installer a second time to add it back in.
I'll run a few more tests to see what's necessary, but removing everything couldn't hurt.

I did note that without the Cypress board connected, I can use the virtual buttons in Compatibility mode, but not the buttons in Enhanced mode.

[sircedric4]

I did note that without the Cypress board connected, I can use the virtual buttons in Compatibility mode, but not the buttons in Enhanced mode.

This is exactly the same issue we were having. None of the virtual buttons work in Enhanced mode. We'll look at the procedure above this one, and keep an eye on your progress.

It is a huge relief to know we aren't alone with our issue. I didn't even know how to start.

[Greg McKaskle]

I'm not sure what the documentation says, but I don't believe the enhanced screen was intended to work virtually.

Greg McKaskle