|
|
|
 Just think of the deadline as your six week deadline for FIRST, just when you think you can't do it, you are amazed by what you can do. - JackN [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Just think of the deadline as your six week deadline for FIRST, just when you think you can't do it, you are amazed by what you can do. - JackN [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Jaguar - Speed controlling 2 motors
So we have two motors tied together in a transmission. We have an encoder attached to the output shaft from transmission.
We want to use the Jag/CAN control with PID to set speeds for these two motors. How can we do that in Labview without the two Jaguar's fighting each other? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode