|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Replacement for Locking Pin (Window Motors)
We went through and removed the locking pins from the Denso window motors, but due to the small nature of them, we lost them. When testing the arm, we found that without the pins, the arm did not support itself and gravity was able to pull it down. Is there any way to make a replacement for these locking pins out of a similar material? Or any solution we could use to not have gravity overpower the motor?
|
|
#2
|
|||
|
|||
|
Re: Replacement for Locking Pin (Window Motors)
If you send me a PM with your address, I'll send you the pins from 2 of our motors.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|