Fun Noodles on Mini Bot

[Duke461]

Originally Posted by mac

As an inspector. It's not on either list:FTC kit of parts or Tetris parts. PVC is the family of pipe, connectors and all fittings, etc.
Thomas McCubbin Team 686

So, your answer is no?

[cire]

Originally Posted by Duke461

So, your answer is no?

In general the GDC has been saying "If it as marketed as such and such then it is allowed." So if it were to be marketed as PVC, then it probably would be usable. You could always turn something marketed as PVC into pool noodles, but you would have to provide proof that you did it.

You can ask the GDC if you want to be sure.

[GaryVoshol]

<R92>Q allows only PVC pipe and fittings, not every form of PVC. If you can make it out of pipe and fittings, you're good. Else, not.

[TD912]

You could put the padding on the hostbot, so the minibot falls down onto it...

[zbanks]

Even though it's not allowed, the OP has a point. It'd be nice for an update to allow pool noodles because there are no other materials allowed that would make an obvious "bumper."

I'd feel so much better about my minibot if it had padding on the bottom for its descent...

[PAR_WIG1350]

Originally Posted by TD912

You could put the padding on the hostbot, so the minibot falls down onto it...

I don't see why not

[Duke461]

Originally Posted by PAR_WIG1350

I don't see why not

It would then be considered functional

[EricH]

Originally Posted by Duke461

It would then be considered functional

That wouldn't be a problem on the Hostbot.

[Nathan Streeter]

Originally Posted by Duke461

It would then be considered functional

But it'd be part of the robot, as it wouldn't climb the tower. It'd be part of the deployment mechanism. There's no rule (or intent for a rule) to prohibit padding from being placed on the deployment mechanism.

[Duke461]

My bad. I thought it said minibot. Ignore the previous post