Our Crio Won't Run deployed Code and there are no Error messages

[sam_who]

Are you enabling the robot?

When the crio reaches some magic point during its boot sequence, the signal light starts blinking rapidly. Once the crio is fully booted and ready to be enabled, the signal light blinks more slowly than before. When the robot is enabled, the signal is on with very minimal blinking. For all intents and purposes, the signal light is on steady.

Once you see the above three states, you'll know what I'm talking about.

The driver station has a setup tab. Is the team number set correctly?

One last thing while I'm thinking about it. Does the driver station show the battery voltage?