Programming PSoC FirstTouch 3 into Labview

FIRST is here to inspire you, to challenge you. Part of that process is giving you a task too hard, resources too little, people too many, time too short. - ebarker [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Programming PSoC FirstTouch 3 into Labview

Thread Tools

Rate Thread

Display Modes

08-02-2011, 14:08

Mark McLeod Mark McLeod is offline

Just Itinerant

AKA: Hey dad...Father...MARK

FRC #0358 (Robotic Eagles)

Team Role: Engineer

Join Date: Mar 2003

Rookie Year: 2002

Location: Hauppauge, Long Island, NY

Posts: 8,808

Mark McLeod has a reputation beyond repute

Re: Programming PSoC FirstTouch 3 into Labview

Just wire your buttons between the Cypress pin specified in your Enhanced setup and ground. The pins are marked on the back of the Cypress board.

On the Cyress you can use wirewrap, a prototype board, or a custom mount from eStop to make the connections.

No programming of the Cypress is required. The default FIRST program sets up the buttons through the Driver Station I/O tab.

__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:50.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.