Driver Station can't communicate to the cRIO

[Anupam Goli]

Hello all,

I have been having a problem communicating to the driver station from a laptop to the cRIO. I am using an ethernet cable hooked up to port 1 straight from my laptop (I have checked the IP settings), and no matter what I do, there is not communication to the robot (the no robot communication thing goes up). I have downloaded code onto the robot through the same laptop. The Enet link light is up when I go to the diagnostics tab, and the Radio sometimes blinks green but immediately goes grey then. Is anyone else having this problem? The Status light only flashes orange after rebooting and then goes off. The power light is the only one that stays on. Any solutions?