|
|
|
 Of course, every team in FTC should be asking the magic question: "What would Simbotics do?" - Billfred [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Of course, every team in FTC should be asking the magic question: "What would Simbotics do?" - Billfred [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#15
10-02-2011, 09:03
|
||||
|
||||
|
Re: Mecanum Wheel Setup Help
Quote:
Yes, that is what the rollers should look like "from the carpet", but... No, the figure must be a "top view" not a "carpet view" because of the way the force vectors are drawn. If the figure were intended to be a "carpet view" then the force vectors would be wrong. So, if it's a top view then the rollers are shown incorrectly; if it's a carpet-view then the force vectors are drawn incorrectly. Last edited by Ether : 10-02-2011 at 09:11. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mecanum Wheel Considerations | abross | General Forum | 20 | 23-01-2010 19:34 |
| HELP: Mecanum wheel Inside spacers | Sam2197 | Technical Discussion | 2 | 19-01-2010 23:36 |
| Mecanum wheel size | Mr. A | Technical Discussion | 7 | 18-01-2010 08:58 |
| pic: New mecanum wheel? | scottydoh | Extra Discussion | 5 | 16-01-2010 21:29 |
| pic: Micro Mecanum wheel | Tytus Gerrish | Extra Discussion | 6 | 12-05-2005 23:20 |
Threaded Mode