Can't get PWM wires to attach on the side car

...your mentors are your friends. If you're not sure of something, they probably know the answer to it, and if they don't, they will point you to someone who does. - Karibou [more]

		Chief Delphi > Technical > Electrical
Can't get PWM wires to attach on the side car

Thread Tools

Rate Thread

Display Modes

11-02-2011, 09:22

Al Skierkiewicz Al Skierkiewicz is offline

Broadcast Eng/Chief Robot Inspector

AKA: Big Al WFFA 2005

FRC #0111 (WildStang)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 1996

Location: Wheeling, IL

Posts: 10,795

Al Skierkiewicz has a reputation beyond repute

Re: Can't get PWM wires to attach on the side car

Jon,
I suspect you are 1 pin off. Each PWM output block has an associated 6 volt enable jumper right next to it. I suspect you are trying to push your PWM cable so that one pin is on the 6 volt block and the others are not lining up with the PWM output pins. Use the flashlight approach until you are confidant.

__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:29.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.