|
|
|
 So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Distance from side of field to pegs
We've been working on our autonomous code with line tracking, and we can't find what seems to be an important dimension in the field drawings we have.
After searching through the field docs, we can't find the distance from the long side (54') of the field to the pegs. We're trying to figure out where the "Y" in the gaffer's tape stops, but we're at a loss as to how to find the location of the ends without a measurement to the pegs they end on. Anybody have this? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode