ball bearings.... - Chief Delphi

All screws are not created equal. - Al Skierkiewicz [more]

		Chief Delphi > Technical > Kit & Additional Hardware
ball bearings....

Thread Tools

Rate Thread

Display Modes

#15

13-02-2011, 13:17

PAR_WIG1350 PAR_WIG1350 is offline

Registered User

AKA: Alan Wells

FRC #1350 (Rambots)

Team Role: Alumni

Join Date: Dec 2009

Rookie Year: 2009

Location: Rhode Island

Posts: 1,190

PAR_WIG1350 has a reputation beyond repute

Re: ball bearings....

I would think if you had an unfinished roller that was still attached to the pipe it was made out of to show the inspector, they would probably accept that (basically, it would have to be finished except for the step in which it is actually separated from the pipe). This might require some creative machining on your part.

__________________

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:09.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.