Labview Timed Loop

[jhellr13]

Originally Posted by Ether

Yes. Make sure you put a flexible extension on the limit switch so that the arm's momentum does not destroy it.

Yes. I was gonna do that to avoid damage.
For programming this, i know how to set up a limit switch, but is their any special programming i need to do to make it work in this case?

[Ether]

Originally Posted by jhellr13

Yes. I was gonna do that to avoid damage.
For programming this, i know how to set up a limit switch, but is their any special programming i need to do to make it work in this case?

Whenever the switch is activated, de-power the motor in the direction that activated the switch, but allow power in the opposite direction (if commanded).