Pushing powered off robots?

[sanddrag]

Done it for a decade with Victors with never a single failure because of it. I can't comment on the Jaguars.

[Hawiian Cadder]

depends on how hard you push it, if you are doing minor adjustment, it doesn't matter because there are diodes in the jags to protect the processors from electrical damage, however be careful because you can destroy the diodes and put some real current through the jags.

[Mr.G]

We have fried at least 4 victors over the years from students pushing the robot fast down long halls at the school.

Trust me don't do it.

[Al Skierkiewicz]

There is no real damage that can be done to speed controllers from pushing the robot if the robot is turned off. Each of the speed controllers has reverse diodes built into the FETs that are part of the output circuitry and these diodes pass current generated in the motors back to the 12 volt buss. However, you cannot possibly push at the top speed of the robot, so it is unlikely you can generate enough voltage to exceed the 12 volts. You will see the LEDs on the Victors turn on and you may see some other indicators come on while pushing. When you push, you are generating voltage similar to the robot in "coast" when the throttle is zero.